You should not use a chainsaw in the rain due to increased safety risks. Rain reduces grip, visibility, and footing, which raises the chance of kickback and slips. Wet conditions also increase electrical risk with […]
You can cut wet wood with a chainsaw without damaging the tool. Chainsaws are designed to cut green or wet wood efficiently. Wet wood cuts more slowly and creates heavier sawdust, which increases chain friction. […]
The pitch on a chainsaw chain is the distance between three consecutive rivets divided by two. Chain pitch determines chain size and compatibility with the guide bar and sprocket. Common chainsaw chain pitches include 1/4 […]
A new Stihl chainsaw usually does not start because of incorrect starting procedure, stale fuel, a flooded engine, or an engaged chain brake. Cold engines require choke activation, fresh 50:1 fuel mix, and proper priming. […]
Start a Stihl MS250 chainsaw by engaging the chain brake and setting the master control lever to full choke. Pull the starter rope until the engine burps, move the lever to half-choke, pull again until […]
A chainsaw cuts crooked due to an unevenly sharpened chain where teeth on one side are longer or filed at a different angle. Other common causes include uneven bar rail wear, improper chain tension, a […]
Use a chainsaw file guide by matching the file size and guide angle, typically 30°, to your chain. Align the guide with the cutter angle and direction arrow, file forward with even strokes, lift on […]
Portland chainsaws are made for Harbor Freight Tools by various overseas manufacturers. Harbor Freight owns the Portland brand and uses it for budget-friendly gas and electric chainsaws. These chainsaws are not made by major brands […]
Your chainsaw chain keeps coming off because the chain tension is too loose. Chain derailments also occur from worn bars, sprockets, or chains, incorrect chain size or type, poor tensioning technique, or new chains stretching […]
Clean a STIHL chainsaw by removing the bar and chain, then brushing or blowing out sawdust from the sprocket area, bar groove, cooling fins, and air filter. Remove burrs, clean with resin solvent if needed, […]